DIY (25) – Plushie – Penguin

Hi everyone,

Perhaps you always thought that doing a plushie is quite difficult?

Then you will see that by following this tutorial it isn’t difficult at all! Today we will see how to create a penguin.

Let’s start!

DIY N. 25



30 cm x 60 cm piece of black Polar fleece -30 cm x 16 cm piece of white Polar fleece – Small amount of tan (for the feet and beak) – Small amounts of felt for the eyes. – 250g of toy fill – penguin pattern (below)

Start by downloading the Penguin Pattern.

Sew the white front body piece on to one piece of the black body piece. Use your picture for direction.

Sew your feet pieces together. Make sure to stitch on the outside.

With the white section facing inwards sew the two black body pieces together. Sew the feet in place as you go (make sure the feet are facing inwards). Leave a gap down one side for turning  – approximately where the wing will fall.

Fill the body with Toy Filling or Wadding and stitch up the gap.

Stitch your wing pieces together but leave a gap for turning. Once turned – do not stuff.

Stitch up the gap and stitch in place (the curved edge goes to the back).

Stitch the wings to the Penguin’s body.

Stitch the beak in the same way as the feet with the stitching on the outside.

Stitch your face features on using the picture for direction.

And it’s finished!

original post:


Inserisci i tuoi dati qui sotto o clicca su un'icona per effettuare l'accesso:

Logo di

Stai commentando usando il tuo account Chiudi sessione /  Modifica )

Google photo

Stai commentando usando il tuo account Google. Chiudi sessione /  Modifica )

Foto Twitter

Stai commentando usando il tuo account Twitter. Chiudi sessione /  Modifica )

Foto di Facebook

Stai commentando usando il tuo account Facebook. Chiudi sessione /  Modifica )

Connessione a %s...

Questo sito utilizza Akismet per ridurre lo spam. Scopri come vengono elaborati i dati derivati dai commenti.