Today we will see the best technique for making the most perfect tassel, as well as a garland to which you can add an excess of pom poms.
DIY N. 38
Omegacryl yarn (thin) or wool yarn (thick) – Tassel comb – large eye blunt needle – scissors
Start by cutting 3 lengths of yarn in 3 different colors. Tie one end into a double knot and braid the yarns. Finish it with another double knot.
For longer tassels, you can use a rectangular notepad or book. The width, or length, of whatever surface you wrap with will be the length of your tassel. Start winding the yarn – for a thick, plump tassel, I like to wind about 100 times around.
Once you’re done wrapping, cut through one end. Lay the yarns flat. Cut a 8-10 inch piece of yarn and slide it under the yarns, right at the middle.
Take the end of your braided yarn and place it along the middle of the yarn, lengthwise. Pull the double knot just past the midway point. Nestle the knot into the middle of the pile of yarns.
Tie the short piece of yarn around the middle and tie into as tight of a double knot as you can.
Pick up the braided cord and the yarns fall loose. This is where the tassel comb seriously comes in handy!!
Slide another 6-8″ piece of yarn under the tassel, about 3/4″ down from the top. Tie into a tight double knot.
With a secondary color, take one end of yarn and fold the end in half to the desired length of the wrapped section. Align the loose end to the very top of the tassel. Start wrapping the yarn around the top of the tassel. Be sure to leave the tail end sticking out. You’ll need that later. Continue wrapping until you’ve reached your desired length. Once you’ve reached your desired length, without going past the bottom yarn loop, trim the working yarn, leaving about 2 inches. Stick that end through the loop.
Take the end of the yarn at the top of the tassel and start to pull. The loop at the bottom should start to move, along with the other end of the yarn. Just be sure not to pull that loop out from the top of your wrapped section. Trim both ends.
Trim the ends and make another tassel on the other end of the braided cord.