For this project you just have to be patient in cutting the hexagonal shapes (the templates at the bottom of the post) that will compose this beautiful lamp.
Here you see it in cardboard, but you can do it in a lot of other materials.
Be careful only to use LED bulbs that do not overheat, avoiding accidents.
DIY N. 137
colored or simple cardboard (but as mentioned above you can also create it in other materials) – cutter – hot glue – light bulb – template (below)
First, print the templates above to the extent you prefer (be careful to enlarge them all by the same percentage, otherwise you will have problems assembling the lamp). Remember to make a hole in one of the hexagons that will compose the base so as to pass the wire of the lamp.
Transfer them to the card or the material you have chosen and cut out all the pieces (you will need a total of 40: 5×8)
For the base, cut squares following the size of the base of the largest hexagon.
Assemble the base first and then the lamp with hot glue.
I hope you liked today’s craft!!!
See you tomorrow with another DIY!!!